水噴霧アルニコ粉末の磁気特性に及ぼす熱処理の影響 Effect of Heat-treatment on Magnetic Properties of Water-atomized Alnico Powder

この論文にアクセスする

この論文をさがす

著者

抄録

The objective of the present work is to develop plastic bonded Alnico magnet for high-quality electronic display or other applications. Here Alnico powders were produced by water-atomization (W/A) instead of cast-crushing method as usual. When W/A Alnico powder was held in the range 1000-1100K for a few minutes and then aircooled, the magnetic properties was wholly improved: practically, 2%Co- and 24%Co-bearing Alnico powders showed the coercive force (Hcj) of more than 6000e and 9000e, respectively. Subsequently, plastic bonded magnet, when press-compacted, showed the maximum energy products (BH)max : 0.45MGOe for 2%Co and 0.67MGOe for 24%Co (packing factor: approximately 65%). As a whole, W/A Alnico powder is of almost the same magnetic properties and further, is expected to be less costy as compared with cast-crushed one.

収録刊行物

  • 粉体および粉末冶金  

    粉体および粉末冶金 44(5), 495-500, 1997-05-15 

    Japan Society of Powder and Powder Metallurgy

参考文献:  4件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10002013971
  • NII書誌ID(NCID)
    AN00222724
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    05328799
  • NDL 記事登録ID
    4205767
  • NDL 雑誌分類
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL 請求記号
    Z17-274
  • データ提供元
    CJP書誌  NDL  J-STAGE 
ページトップへ