TiN粒子を添加したTiAl合金の高温変形挙動 Deformation Behavior at High Temperatures in TiAl Alloys Containing TiN Particles

この論文にアクセスする

この論文をさがす

著者

抄録

Using pure Ti, Al and TiN powders as starting materials, TiAl base composites were produced by MA-HIP method. Microstructures and mechanical properties at elevated temperatures were investigated for HIPed compacts in addition to the MA process. Results are as follows. Though the mixed state was mostly maintained even after MA treatment, the formation of amorphous phase was confirmed in part. With the increase of volume percent of TiN particles, microstructures of HIPed compacts became finer. Ti<SUB>2</SUB>AIN phase was observed as well as TiAl and Ti<SUB>3</SUB>Al phases for compacts for which TiN was added initially. This shows the occurrence of the reaction between TiAl and TiN during sintering. The flow stress was increased with increase of TiN volume percent and the effect of dispersion strengthening was not on the decline at higher temperatures. The strain rate sensitivity exponents (m values) were found to be 0.45 at 1373K for matrix and 10vol%TiN alloys, suggesting the development of superplasticity.

収録刊行物

  • 粉体および粉末冶金  

    粉体および粉末冶金 44(6), 577-581, 1997-06-15 

    Japan Society of Powder and Powder Metallurgy

参考文献:  8件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10002014111
  • NII書誌ID(NCID)
    AN00222724
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    05328799
  • NDL 記事登録ID
    4228298
  • NDL 雑誌分類
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL 請求記号
    Z17-274
  • データ提供元
    CJP書誌  NDL  J-STAGE 
ページトップへ