Fabrication of Si3N4/SiC Composite Ceramics by Reactive Hot-Pressing from Elemental Powders.

DOI Web Site 参考文献20件
  • Ohtsuka Takeshi
    Graduate School, Osaka Prefecture University
  • Mabuchi Hiroshi
    Department of Metallurgy and Materials Science, College of Engineering, Osaka Prefecture University
  • Tsuda Hiroshi
    Department of Metallurgy and Materials Science, College of Engineering, Osaka Prefecture University
  • Morii Kenji
    Department of Metallurgy and Materials Science, College of Engineering, Osaka Prefecture University

書誌事項

タイトル別名
  • Fabrication of Si3N4 SiC Composite Cera

この論文をさがす

抄録

Using elemental powders, reactive hot-pressing was carried out to prepare Si3N4/SiC composite ceramics. Silicon and graphite powders with additives (Al2O3 and Y2O3) were reacted at 1873K in gaseous nitrogen (0. 15MPa) and hot-pressed at 2073K for 7.2ks with applied pressure of 70MPa, and finally formed a Si3N4(β-Si3N4)-SiC(β-SiC) composite with a small amount of glassy and crystalline phases from additives. The resulting composites had 12-34vol%SiC, and the SiC grains were granular with sizes of about 0.1-1μm, and homogeneously distributed and well bonded to the matrix Si3N4. On the other hand, the Si3N4 matrix grains were rod-like in shape with sizes of 0.3-3μm. It was found that the composite ceramics had a relatively higher bending strength at both ambient and elevated (at 1423K) temperatures; about 1000 and 700 MPa, respectively. Fracture toughness of 5.3 MPam1/2 was obtained by indentation fracture tests. It was evident that reactive hot-pressing was very effective process for in-situ synthesis of Si3N4/SiC composite ceramics.

収録刊行物

参考文献 (20)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ