射出成形プロセスを用いた各種高機能焼結材料 Various High Functional Sintered Materials by Injection Molding Process

この論文にアクセスする

この論文をさがす

著者

    • 三浦 秀士 MIURA Hideshi
    • 熊本大学工学部知能生産システム工学科 Dept. Mech. Eng. & Mat. Sci., Fac. Eng., Kumamoto University

抄録

Metal injection molding (MIM) process offers near full dense and net shaping of the complicate parts with a relatively low processing cost. Therefore, this MIM process is hoped to be an advanced powder processing technique for fabricating new and high functional materials, especially seems to be quite useful for improvement of the quality and productivity in the automotive sintered parts.<BR>In this work, MIM process has been applied to a wide variety of ferrous materials such as structural steels (4100, 4600 systems), high speed steels, 17-4PH and martensitic stainless steels, and ferrous composites with ceramics. Several processing variations were investigated to control the carbon and microstructure for high strengthening the above steels. Comments are particularly focused on the microstructure control needed for the MIM fabrication of high performance and functional sintered ferrous material components.

収録刊行物

  • 粉体および粉末冶金  

    粉体および粉末冶金 45(5), 405-411, 1998-05-15 

    Japan Society of Powder and Powder Metallurgy

参考文献:  15件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

被引用文献:  2件

被引用文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10002015551
  • NII書誌ID(NCID)
    AN00222724
  • 本文言語コード
    JPN
  • 資料種別
    REV
  • ISSN
    05328799
  • NDL 記事登録ID
    4481793
  • NDL 雑誌分類
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL 請求記号
    Z17-274
  • データ提供元
    CJP書誌  CJP引用  NDL  J-STAGE 
ページトップへ