SUS304L長尺物の金型成形 Die Compacting of SUS304L Lengthwise Parts

この論文にアクセスする

この論文をさがす

著者

抄録

The application range of sintered machine product can be extended by the diecompacting of lengthwise parts which is one of restrictions in a geometric shape.<BR>In this paper, the dimensional precision of lengthwise SUS-304L sintered compacts was improved by high pressure die compacting. The stainless steel powder isdifficult to compact at high pressure because of adhesion between the powder and the die during ejection. The two-step pressing that we proposed as the high pressure die compacting has made it possible to compact at a pressure of 980 MPa.<BR>The result is a decrease of dimensional change with increasing a compacting pressure. However, there is a definite difference between the dimensional change of the center diameter and that of the end diameter in the longituditinal direc-tion of sintered compact. It is presumed that the lengthwise sintered compact distorts, as a consequence of the uneven dimensional change. Then, the cylindri- city indicated by measurement of roundness was inspected. The cilindricity of the compact at 884MPa is reduced by approximately half, as compared with that of the compact at 490MPa. Thus, the high pressure compacting by this method was found to be effective not only for the increase of the density but also for the improvement of dimensional precision.

収録刊行物

  • 粉体および粉末冶金  

    粉体および粉末冶金 45(5), 420-424, 1998-05-15 

    Japan Society of Powder and Powder Metallurgy

参考文献:  7件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

被引用文献:  3件

被引用文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10002015576
  • NII書誌ID(NCID)
    AN00222724
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    05328799
  • NDL 記事登録ID
    4481796
  • NDL 雑誌分類
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL 請求記号
    Z17-274
  • データ提供元
    CJP書誌  CJP引用  NDL  J-STAGE 
ページトップへ