Load-Elongation Behavior of Fiber-Oriented Manila Hemp Sheets.

DOI Web Site Web Site 被引用文献1件 参考文献28件

この論文をさがす

抄録

Fully restrained fiber-oriented sheets, machine-made paper, and handmade sheet by the standard method were prepared from Manila hemp pulp. Strain-to-failure of the fiber-oriented sheets was almost the same in both the machine (MD) and the cross machine (CD) directions, while a distinct direction-dependence was observed in the machine-made paper. This indicates that a degree of fiber orientation of paper is not a dominant factor controlling strain at break. Furthermore, dried-in shrinkage in CD of the machine-made paper can be simply estimated by comparison of strain-to-failure of this paper with that of the fully restrained fiber-oriented sheet or the handmade sheet prepared. Uneven profile of strain-to-failure in CD of the machine-made paper is observed over the width direction. This profile may possibly be explained by analogy of the geometrical and mechanical conditions of the wet web at the dryer pocket with those of the short span thin body. Notable acoustic emission (AE) from the specimens sampled from both edge and center of the dried web in the elongation test was not observed except at the final stage of plastic region. The result indicates that difference of strain-to-failure between them is attributed to a different degree of dried-in shrinkage since structural breakage like bond failure or fiber breakage which may happen in plastic deformation causes emission of elastic wave.

収録刊行物

  • 繊維学会誌

    繊維学会誌 55 (3), 127-133, 1999

    社団法人 繊維学会

被引用文献 (1)*注記

もっと見る

参考文献 (28)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ