ダイカスト金型内のガス圧解析と鋳造への応用 Analysis of Gas Pressure in Die Cavity and Its Application to Die Casting

この論文にアクセスする

この論文をさがす

抄録

  Reducing the trapped gas quantity is important in die casting. In this study, first, the analytical formula to calculate the gas quantity in a die cavity during injection was derived and experimentally confirmed. Secondly, the effective casting conditions for reducing the gas quantity were calculated by using the formula. Casting techniques to reduce the gas quantity were mainly in such factors as low speed injection, longer stroke of low speed injection, and delaying time of blocking up the air vent by molten metal. In the case of conventional high speed die castings, most of the gas initially retained in a cavity was found to remain. This was due to an inappropiate air vent design which did not have a suitable dimension corresponding with the metal charging rate. Concerning the method of reduction of remaining gas, it was concluded that was low speed charging process was necessary if small air vent was inevitable, or was big air vent must be adopted if high speed injection was needed.

収録刊行物

  • 鋳造工学 = Journal of Japan Foundry Engineering Society  

    鋳造工学 = Journal of Japan Foundry Engineering Society 68(6), 499-505, 1996-06 

    Japan Foundry Engineering Society

参考文献:  7件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10002113658
  • NII書誌ID(NCID)
    AN10514770
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    13420429
  • NDL 記事登録ID
    3976376
  • NDL 雑誌分類
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL 請求記号
    Z17-277
  • データ提供元
    CJP書誌  NDL  J-STAGE 
ページトップへ