アルミニウム偏平粉末の特性に及ぼすミリング条件の影響 Effect of Milling Conditions on Characteristics of Al Flake Powder

この論文にアクセスする

この論文をさがす

著者

抄録

Tumbler-ball milling of Al powder was carried out to investigate the effect of milling conditions on the characteristics of Al flake powder particles for fingerprint detection. Initial powder of under 25μm was more easily developed to flake particles have high specific surface area than under 19μm one. With an increase in the ball size from 4.8 to 16mm, the specific surface area of the milled powder particles increases and then decreases at 16mm. The specific surface area of the milled powder particles increased with increasing mill container rotation speed. The excellent fingerprint detection qualities were obtained in milling condition of under 25μm initial powder, 9.5mm ball size, 80rpm mill container rotation speed and 40 hours milling time. The diameter of the flake particles estimated from the impact velocity of the balls based on the milling ball dynamics and the Hertz contact theory was compared with the measured one.

収録刊行物

  • 粉体および粉末冶金  

    粉体および粉末冶金 43(10), 1253-1258, 1996-10-15 

    Japan Society of Powder and Powder Metallurgy

参考文献:  11件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10002260864
  • NII書誌ID(NCID)
    AN00222724
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    05328799
  • NDL 記事登録ID
    4057331
  • NDL 雑誌分類
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL 請求記号
    Z17-274
  • データ提供元
    CJP書誌  NDL  J-STAGE 
ページトップへ