自動車焼結部品の研究課題評価 R & D Priority Assessment of Automotive P/M Parts

この論文にアクセスする

この論文をさがす

著者

    • 櫻井 茂徳 SAKURAI Shigenori
    • トヨタ自動車(株)第4開発センター第1材料技術部 Material Engineering Div. I. Component & System Development Center, Toyota Motor Corporation

抄録

Facing with the Mega Competition Age, P/M industry in Japan has recognized that collaboration among firms and academics, particularly in the basic and scientific fields, may be the most effective procedure for increasing P/M industry competitiveness. In this paper, assessment of P/M R&D priorities, which was conducted by " JSPM Automotive Sintered Parts Committee " estab-lished in 1995, is reported. 50 participants, including academics, end users, part suppliers, powder producers, replied to an R&D priority questionnaire. The questionnaire consisted of 12 questions concerning fatigue, compaction, dimensional accuracy, densification, powder improvement, standardization of test methods and joining technique. Fundamental study on P/M Fatigue and Computer Simulation for powder compaction were given top R&D priorities.

収録刊行物

  • 粉体および粉末冶金  

    粉体および粉末冶金 43(11), 1307-1312, 1996-11-15 

    Japan Society of Powder and Powder Metallurgy

参考文献:  4件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10002260977
  • NII書誌ID(NCID)
    AN00222724
  • 本文言語コード
    JPN
  • 資料種別
    REV
  • ISSN
    05328799
  • NDL 記事登録ID
    4077932
  • NDL 雑誌分類
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL 請求記号
    Z17-274
  • データ提供元
    CJP書誌  NDL  J-STAGE 
ページトップへ