誘導焼結法による炭素鋼の急速焼結技術の開発 Development of Rapid Sintering Technique on Carbon Steels by the Induction Heating Method

この論文にアクセスする

この論文をさがす

著者

抄録

From the purpose of rapid sintering technique within a few minutes, this study was used the green compact of die assembly's lubricant method. Specimen were composited 0.8mass%C-1.5mass%Cu-bal. Fe powders, and used to the high frequency induction heating instrument. By the rapid sintering method, there is very important factor both the removal of adsorbed gas in powder grain surface and accompanied by the diffusion and sintering of each powder. As a result, the isothermal treatment (1223K-90s) when the sintering process in this experiment was a key technology treatment. That is to say, this new sintering method obtaind more radial crushing strength values than that of the conventional furnance process. This method was finished to sinter only 3 minutes, and it's condition was maximum heating time-30s, sintering condition 1523K-60s and isothermal treatment-90s holding only.

収録刊行物

  • 粉体および粉末冶金  

    粉体および粉末冶金 46(5), 538-543, 1999-05-15 

    Japan Society of Powder and Powder Metallurgy

参考文献:  8件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

被引用文献:  6件

被引用文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10002262518
  • NII書誌ID(NCID)
    AN00222724
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    05328799
  • NDL 記事登録ID
    4737376
  • NDL 雑誌分類
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL 請求記号
    Z17-274
  • データ提供元
    CJP書誌  CJP引用  NDL  J-STAGE 
ページトップへ