ワイヤ放電加工の加工シミュレーション -第1報 解析方法と解析例- Simulation of Wire EDM(1st Report) -Simlating Procedure and Examples-

この論文にアクセスする

この論文をさがす

著者

抄録

Precisions of Wire-EDM are spoiled by a wire deflection and a wire vibration during the machining. Examples, these wire behaviors cause a smoothed corner or a smaller radius corner shape and a concave cut wall.<br>As well known, these wire behaviors are caused by a explosive pressure, a electrostatic force, a electromagnetic force by each discharge and a force caused by flushing of water during Wire-EDM.<br>In previous some papers, wire behaviors are measured and discussed. And other papers reported methods to solve problems of cutting precisions.<br>But in spite of these reports, wire behaviors and the influence of EDM conditions on them are not so cleared, also the relation between cutting accuracy and wire behaviors is not so well understood yet.<br>For these investigations, simulations of Wire-EDM will be useful. But the simulation of Wire-EDM is quite different from them of conventional EDM because all process and repetition from voltage supply to discharge, explosion, machining and wire movement should be considered.<br>In this report we mainly describe a simulating procedure and few nalyzed results of Wire-EDM.

収録刊行物

  • 電気加工学会誌  

    電気加工学会誌 29(62), 40-48, 1995-11-01 

    Japan Society of Electrical Machining Engineers

参考文献:  12件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

被引用文献:  9件

被引用文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10002439496
  • NII書誌ID(NCID)
    AN00151681
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    0387754X
  • データ提供元
    CJP書誌  CJP引用  J-STAGE 
ページトップへ