Geometrical Characteristics of Pulsed Current Positional GMA Weld.

DOI Web Site 被引用文献3件 参考文献14件
  • Randhawa H. S.
    Welding Research Laboratory, Department of Mechanical and Industrial Engineering, University of Roorkee
  • Ghosh P. K.
    Welding Research Laboratory, Department of Mechanical and Industrial Engineering, University of Roorkee
  • Gupta S. R.
    Welding Research Laboratory, Department of Mechanical and Industrial Engineering, University of Roorkee

この論文をさがす

抄録

Vertical up positional welding of structural steel plate was performed by pulsed current GMAW process employing comparatively high mean currents of 100 and 130 A, resulting an enhanced deposition rate. The use of welding current of conventional continuous current GMAW at similar order to those of the mean currents of the pulsed current GMAW process is found unsuitable in present conditions of welding. However, the geometrical characteristics of the weld are found to be largely governed by the pulse parameter of the GMAW process and they are well correlated to a factor φ defined as a summarized influence of pulse parameters such as peak current, base current, pulse off time and pulse frequency. The increase in φ at a lower mean current is found favourable to obtain acceptable weld geometry, especially with respect to the form factor and toe angle of the top reinforcement of the weld.

収録刊行物

被引用文献 (3)*注記

もっと見る

参考文献 (14)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ