Origin of Recrystallization Texture Evolution and Active Slip Systems in Cold Rolled 3%Si-Fe(100)[001]Single Crystal

この論文にアクセスする

この論文をさがす

著者

    • TOGE Tetsuo
    • Electrical Steel Laboratory, Technical Research Laboratories, Kawasaki Steel Corporation
    • MURAKI Mineo
    • Electrical Steel Laboratory, Technical Research Laboratories, Kawasaki Steel Corporation
    • KOMATSUBARA Michiro
    • Electrical Steel Laboratory, Technical Research Laboratories, Kawasaki Steel Corporation
    • OBARA Takashi
    • Research Planning and Administration Department, Technical Research Laboratories, Kawasaki Steel Corporation

抄録

3%Si–Fe (100)[011] single crystal was investigated to analyze its texture evolution during rolling and recrystallization. Cold rolled (100)[011] could be fully recrystallized by utilizing dynamic strain aging, and sharp recrystallized texture was obtained.<br> Rolled texture maintained the initial orientation (100)[011] with TD rotational dispersion. This dispersion is attributed to the action of two kinds of {112}<111> slip systems which have the largest Schmid factor. <br> Recrystallized texture is composed of eight orientations rotated about 30 degrees around eight <112> axes from the initial orientation (100)[011]. These rotations are attributed to the action of 8 kinds of {110}<111> slip systems. <br> The results of several researchers, showing recrystallized {111}<<I>uvw</I>> grains from the rolled matrix having {111}<<I>uvw</I>>, were also discussed in this paper from the view point of <112>-rotation, and an alternative idea on the formation of <111>//ND texture has been proposed.

収録刊行物

  • ISIJ international  

    ISIJ international 38(6), 524-530, 1998-06-15 

    The Iron and Steel Institute of Japan

参考文献:  21件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

被引用文献:  7件

被引用文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

ページトップへ