Recrystallization and Related Phenomena. Effect of Lubrication Condition on Recrystallization Texture of Ultra-low C Sheet Steel Hot-rolled in Ferrite Region.

DOI Web Site 9 Citations 22 References
  • Matsuoka Saiji
    Iron and Steel Research Laboratories, Kawasaki Steel Corporation
  • Morita Masahiko
    Iron and Steel Research Laboratories, Kawasaki Steel Corporation
  • Furukimi Osamu
    Iron and Steel Research Laboratories, Kawasaki Steel Corporation
  • Obara Takashi
    Iron and Steel Research Laboratories, Kawasaki Steel Corporation

Search this article

Abstract

The application of the EBSD technique with an SEM provides a new approach to the analysis of variations of the recrystallization texture in the thickness direction of ultra-low carbon sheet steels rolled in the ferrite region. A nonuniform recrystallization texture through the thickness is formed due to the additional shear strain introduced by frictional force between the rolls and the material in sheet steel rolled with a friction coefficient over 0.15, <110>//ND recrystallized grains being formed near the surface, and <111>//ND and <100>//ND recrystallized grains being formed at the mid plane. On the other hand, <110>//ND recrystallized grains are not formed preferentially near the surface, and <111>//ND and <100>//ND recrystallized grains are formed uniformly throughout the thickness in sheet steel rolled with a friction coefficient under 0.15. Orientation imaging also reveals differences related to the tolerance of <110>//ND recrystallized grains around the <110>//ND axis in sheet steel rolled without lubrication, in that <110>//ND grains with a small tolerance form at the 1/10 plane from the surface and <110>//ND grains with larger tolerances form at thickness locations from the 1/10 plane toward the surface and center. The r-value depends on the friction coefficient and increases significantly as the friction coefficient decreases under 0.15, resulting in high r-values over 1.2. This change in the r-value with the friction coefficient corresponds to the distribution of the recrystallization texture through the thickness. Orientation imaging allows a more visual and intuitive understanding of the nonuniformity of the recrystallization texture than conventional methods such as optical microscopy and X-ray diffraction measurement.

Journal

  • ISIJ International

    ISIJ International 38 (6), 633-639, 1998

    The Iron and Steel Institute of Japan

Citations (9)*help

See more

References(22)*help

See more

Keywords

Details 詳細情報について

Report a problem

Back to top