Effects of Retained Austenite Parameters on Warm Stretch-flangeability in TRIP-aided Dual-phase Sheet Steels

この論文にアクセスする

この論文をさがす

著者

抄録

Effects of volume fraction and carbon concentration of retained austenite on warm stretch-flangeability in high-strength TRIP-aided dual-phase (TDP) sheet steels with different silicon and manganese contents were investigated. A significant improvement of the stretch-flangeability was obtained by warm hole-punching at temperatures between 150 and 200°C and the successive hole-expanding at temperatures between 50 and 200°C, relating to martensite-start temperature of the retained austenite. The warm stretch-flangeability was affected by carbon concentration of the retained austenite rather than by the volume fraction of retained austenite. Namely, the higher the carbon concentration of the retaind austenite, the larger the hole-expanding ratio of the steel. Such a large hole-expanding ratio was resulting from the following two reasons; (1) smaller surface damage and a large amount of retained austenite untransformed on hole-punching and (2) Iarge localized ductility due to the TRIP effect on hole-expanding.

収録刊行物

  • ISIJ international

    ISIJ international 39(1), 56-63, 1999-01

    The Iron and Steel Institute of Japan

参考文献:  17件中 1-17件 を表示

  • <no title>

    ZACKAY V. F.

    Trans. Am. Soc. Met. 60, 252, 1967

    被引用文献21件

  • <no title>

    MATSUMURA O.

    Trans.Iron Steel Inst.Jpn 27, 570, 1987

    被引用文献12件

  • <no title>

    SUGIMOTO K.

    Metall. Trans. A 23A, 3085, 1992

    被引用文献16件

  • <no title>

    SUGIMOTO K.

    ISIJ Int 32, 1311, 1992

    被引用文献33件

  • <no title>

    SUGIMOTO K.

    ISIJ Int 33, 775, 1993

    被引用文献17件

  • <no title>

    MATSUMURA O.

    ISIJ Int 32, 1110, 1992

    被引用文献20件

  • <no title>

    HIWATASHI S.

    J. Jpn. Soc. Technol. Plast. 35, 1109, 1994

    被引用文献15件

  • <no title>

    SUGIMOTO K.

    ISIJ Int 35, 1407, 1995

    被引用文献30件

  • <no title>

    HIROSE Y.

    J. Jpn. Soc. Technol. Plast. 35, 1071, 1994

    被引用文献10件

  • <no title>

    SHIRASAWA H.

    Proc. Int. Symp. on High-Strength Sheet Steels for the Automotive Industry 3, 1994

    被引用文献1件

  • <no title>

    NAGASAKA A.

    Tetsu-to-Hagane 83, 335, 1997

    被引用文献11件

  • <no title>

    NAGASAKA A.

    Tetsu-to-Hagane 84, 218, 1998

    被引用文献3件

  • <no title>

    MARUYAMA H.

    J. Jpn. Soc. Heat Treat. 17, 198, 1977

    被引用文献18件

  • <no title>

    SPEICH G. R.

    Metall. Trans. A 12A, 1419, 1981

    被引用文献4件

  • <no title>

    GILMOUR J. B.

    Metall. Trans. 3, 1455, 1972

    被引用文献3件

  • <no title>

    TAMURA I.

    Trans.Iron Steel Inst.Jpn 10, 163, 1970

    被引用文献5件

  • <no title>

    RADCLIFFE S. V.

    Acta Metall. 10, 201, 1962

    被引用文献3件

各種コード

ページトップへ