Water Model Experiments on Mixing Phenomena in a VOD Ladle

この論文にアクセスする

この論文をさがす

著者

    • KRISHNAKUMAR K.
    • Department of Metallurgical Engineering and Materials Science, Indian Institute of Technology Bombay
    • BALLAL N. B.
    • Department of Metallurgical Engineering and Materials Science, Indian Institute of Technology Bombay
    • SINHA P. K.
    • Department of Metallurgical Engineering and Materials Science, Indian Institute of Technology Bombay
    • SARDAR M. K.
    • Department of Metallurgical Engineering and Materials Science, Indian Institute of Technology Bombay
    • JHA K. N.
    • Department of Metallurgical Engineering and Materials Science, Indian Institute of Technology Bombay

抄録

Mixing phenomena in a VOD ladle were characterized by a watermodel simulation from the determination of mixing times by electrical conductivity measurements. Two mixing times defined for two degrees of mixing, <I>viz.</I>, <I>t</I><sub>95</sub> (95 % mixing) and <I>t</I><sub>99</sub> (99 % mixing) were identified for each experiment. Various operating conditions as well as different placements of bottom nozzle with and without a top jet were simulated. Irrespective of whether the top blow is present or not, mixing rates were found to be increasing considerably as the nozzle position is moved from the center to the mid-radius position. The presence of a top jet, as in a VOD ladle, was found to weaken mixing for both a coaxial and non coaxial placement of the lance with the bubble plume. The results of watermodel experiments have been used to construct a simple two-tank model of mixing inside the actual ladle, in which the parameters are obtained as functions of process variables.

収録刊行物

  • ISIJ international  

    ISIJ international 39(5), 419-425, 1999-05-15 

    The Iron and Steel Institute of Japan

参考文献:  19件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

被引用文献:  1件

被引用文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

キーワード

各種コード

ページトップへ