非対称シリンダを有するサーボ試験機での岩石試験の制御性 Control Performance of Servo-Controlled Testing Machine with Asymmetrical Cylinder

この論文にアクセスする

この論文をさがす

著者

    • 吉見 修 YOSHIMI Osamu
    • 東京大学 工学系研究科地球システム工学 Department of Geo-system Engineering, The University of Tokyo
    • 張 衆 [他] ZHANG Zhung
    • 東京大学 工学系研究科地球システム工学 Department of Geo-system Engineering, The University of Tokyo

抄録

In the previous papers, control performance of servo-controlled testing machines with a symmetrical cylinder was discussed analytically and numerically. An asymmetrical cylinder is widely used to reduce the cost and size of testing machines. However the asymmetrical cylinder has nonlinear characteristics, and the control performance of it is inferior to the symmetrical cylinder. In this paper, the control performance of a servo-controlled testing machine with asymmetrical cylinder is discussed analytically on basis of the experimental results. Uniaxial compression tests using Sanjome-andesite, Akiyoshi-marble and Inada-granite were conducted in order to clarify the control characteristics. Actually, pressures of upper and lower chambers within the cylinder were measured. It was found that the pressures changed depending on the direction of piston movement. The pressure decreased in case of moving to the loading direction, and the amount of pressure decrease was large at high piston velocity. The pressures in the cylinder were analytically examined with aid of a simple model which consisted of a cylinder and a servo-valve. These theoretical results coincided with the experimental results. Sometimes in the post-failure region, the piston tended to move reversely. At that time, the asymmetrical cylinder showed inferior control performance caused by the followings ; 1) Larger amount of oil inflow is necessary. 2) Feedback gain changes depending on the direction of piston movement. The control performance of asymmetrical cylinder can be possibly improved by adjusting the followings; 1) large oil-leakage at the cylinder, 2) variable flow-coefficient at orifice, 3) variable feedback gain.

収録刊行物

  • 資源と素材 : 資源・素材学会誌 : journal of the Mining and Materials Processing Institute of Japan  

    資源と素材 : 資源・素材学会誌 : journal of the Mining and Materials Processing Institute of Japan 114(13), 945-951, 1998-12-25 

    The Mining and Materials Processing Institute of Japan

参考文献:  8件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10002468775
  • NII書誌ID(NCID)
    AN10062646
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    09161740
  • NDL 記事登録ID
    4630885
  • NDL 雑誌分類
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL 請求記号
    Z17-315
  • データ提供元
    CJP書誌  NDL  J-STAGE 
ページトップへ