ADIの炭素鋼に対する耐摩耗性 Wear Resistance of ADI to Carbon Steels

この論文にアクセスする

この論文をさがす

著者

抄録

  ADI has higher strength and toughness compared with FCD, which has consequently led to demands for mechanical components made of ADI. Mechanical components also often require resistance to wear in addition to strength and machinability. In this report, the wear resistance of ADI to normalized and quenched carbon steels (O.1∼0.8 % C) compared with FCD is examined in both the dry state or when lubricated with oil. The results obtained are as follows : The wear losses of ADI (JIS FCAD 900, 1200) and FCD 400 without lubricant decrease with increasing carbon content for quenched carbon steel. FCD 400 permits the largest wear loss and FCAD 1200 the smallest. The wear losses increase with increasing sliding load and sliding speed more than approximately 1.3 m/s, but these rates of increase are greater for FCD 400 than for ADI. While, the wear resistances of ADI and FCD to normalized or quenched carbon steels remarkably improve with the existence of lubricant oil and more of less no difference was observed between the graphite cast irons.

収録刊行物

  • 鋳造工学 = Journal of Japan Foundry Engineering Society  

    鋳造工学 = Journal of Japan Foundry Engineering Society 71(4), 239-245, 1999-04 

    Japan Foundry Engineering Society

参考文献:  10件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10002554981
  • NII書誌ID(NCID)
    AN10514770
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    13420429
  • NDL 記事登録ID
    4718417
  • NDL 雑誌分類
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL 請求記号
    Z17-277
  • データ提供元
    CJP書誌  NDL  J-STAGE 
ページトップへ