SiCp/A383アルミニウム合金複合材料の旋削被削性 Turning machinability of SiCp/A383 aluminum alloy composite

この論文にアクセスする

この論文をさがす

著者

抄録

Turning machinability test were performed on the SiCp/A383 aluminum alloy composite by measuring tool wear, cutting resistance and surface roughness. Shapes of flank wear were changed from band type to triangle type with increase of flank wear. The flank wear were increased with increasing of both cutting speed and cutting distance. The flank wear of the first stage of cutting was very large regardless cutting conditions. It was more than 0.2 mm on cutting distance of 50 mm. Regardless side rake angle, cutting resistance were increased with increasing of both cutting speed and cutting distance. In case of cutting speed on 1.67 m/s, finished surface roughness in the first stage of cutting was large, but finished surface roughness was changed for better with increasing of cutting distance. In case of start of cutting on cutting speed of more than 3.33 m/s, the finished surface roughness become better increased with increase of cutting distance. However finished surface roughness suddenly increased with increase of tool wear.

収録刊行物

  • 軽金属  

    軽金属 48(2), 83-87, 1998-02-28 

    The Japan Institute of Light Metals

参考文献:  13件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

被引用文献:  1件

被引用文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10002664433
  • NII書誌ID(NCID)
    AN00069773
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    04515994
  • NDL 記事登録ID
    4413751
  • NDL 雑誌分類
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL 請求記号
    Z17-284
  • データ提供元
    CJP書誌  CJP引用  NDL  J-STAGE 
ページトップへ