積層Al/Ti箔の常温圧接による複合化 Fabrication of composite materials from multilayered Al/Ti foils by pressure welding at room temperature

この論文にアクセスする

この論文をさがす

著者

抄録

In order to produce metal-matrix-composites by a simple method, it was attempted to fabricate Al/9.7 vol%Ti composite by pressing and by rolling after compression of alternately multilayered pure Al and Ti foils at room temperature. The formation process of Al/Ti composites was examined and tensile properties of the composites were measured. Tensile strength of the composites was compared with the values estimated from the rule of mixture on the flake reinforced composite. Joining of the multilayered Al/Ti foils is attained by nominal compressive stress from 0.5 to 2 GPa at room temperature. The obtained composites consist of dispersed Ti-flakes and Al matrix. The size of Ti-flakes becomes smaller with increasing compressive stress and reduction in cold rolling after compression. Nominal compressive stress of 1.0 GPa gives the highest tensile strength of the Al/Ti composites in the present work. Cold rolling with reduction of 70% after compression at 2 GPa gives lower tensile strength of the Al/ Ti composites than that without rolling.

収録刊行物

  • 軽金属  

    軽金属 49(6), 238-243, 1999-06-30 

    The Japan Institute of Light Metals

参考文献:  20件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

被引用文献:  1件

被引用文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10002666473
  • NII書誌ID(NCID)
    AN00069773
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    04515994
  • NDL 記事登録ID
    4775029
  • NDL 雑誌分類
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL 請求記号
    Z17-284
  • データ提供元
    CJP書誌  CJP引用  NDL  J-STAGE 
ページトップへ