マイクロセルラープラスチックの成形プロセスにおける圧力効果 Effect of Pressure in Processing of Microcelullar Plastics

この論文にアクセスする

この論文をさがす

著者

    • 新保 實 SHIMBO Minoru
    • 金沢工業大学 物質応用工学科 Department of Materials Science and Engineering, Kanazawa Institute of Technology

抄録

Microcellular plastics are a unique cellular material in which voids, smaller than the natural flaw size pre-existing in polymers, are nucleated: this process results in material costs savings without significant reductions and sometimes improvements in mechanical properties. They are characterized by average cell diameter sizes on the order of 0. 1 to 10 μm, cell densities on the order of 10<SUP>9</SUP> to 10<SUP>15</SUP> cells/cm<SUP>3</SUP>, and specific density reductions (relative to the unfoamed plastic) from 5 to 95 percent. In this paper, the basic concept of foaming for microcellular plastics is described and the process technology of microcellular plastics based on that concept is introduced. The effect of pressure in processing of microcelullar plastics is discussed.

収録刊行物

  • 高圧力の科学と技術 = The Review of high pressure science and technology  

    高圧力の科学と技術 = The Review of high pressure science and technology 5(4), 238-241, 1996-11-01 

    The Japan Society of High Pressure Science and Technology

参考文献:  15件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10002848407
  • NII書誌ID(NCID)
    AN10452913
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    0917639X
  • NDL 記事登録ID
    4107224
  • NDL 雑誌分類
    ZP1(科学技術--化学・化学工業)
  • NDL 請求記号
    Z17-1589
  • データ提供元
    CJP書誌  NDL  J-STAGE 
ページトップへ