ベルト型超高圧発生容器内部の応力解析 Estimation of Stress Distribution of Pressure Media in a Flat Belt Type High Pressure Apparatus by the Rigid Plastic Method

この論文にアクセスする

この論文をさがす

著者

抄録

A stress distribution of pressure media in a high pressure apparatus, the flat belt type, was estimated by the rigid plastic method. Since it was so difficult to estimate the stress distribution of that primarily, because of the complicated inner structure of the pressure media, we tried to estimate stress distribution in a diamond anvil cell that had a simple structure. Various kinds of pressure media, copper, pyrophyllite and salt, were used to study the effect of friction factors. The estimated stress distribution of copper in a diamond anvil cell was quite similar to the observed one, when the friction factor was supposed to be a constant at any inner pressure. On the other hand, the estimated stress distribution of pyrophyllite became equal to the observed one, when the friction factor was supposed to be proportional to the 3<SUP>rd</SUP> power of an inner pressure. Finally, the estimated stress distribution of the pressure media in the high pressure apparatus could be equal to the observed one using the supposition of the friction factor being proportional to the 3<SUP>rd</SUP> power of an inner pressure.

収録刊行物

  • 高圧力の科学と技術 = The Review of high pressure science and technology  

    高圧力の科学と技術 = The Review of high pressure science and technology 8(4), 273-279, 1998-11-01 

    The Japan Society of High Pressure Science and Technology

参考文献:  13件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10002849532
  • NII書誌ID(NCID)
    AN10452913
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    0917639X
  • NDL 記事登録ID
    4621290
  • NDL 雑誌分類
    ZP1(科学技術--化学・化学工業)
  • NDL 請求記号
    Z17-1589
  • データ提供元
    CJP書誌  NDL  J-STAGE 
ページトップへ