成形ベルトを付加したメルトドラッグ法によるAl-12%Si合金薄板作製の高速化 Production of Al-12%Si alloy strip in higher roll speed by melt drag process equipped with a forming belt

この論文にアクセスする

この論文をさがす

著者

抄録

In this study, a forming belt was attached on the free solidified surface side of melt drag process which is a kind of single roll process. The purpose of the equipment of forming belt is the improvement of strip production in higher roll speed than conventional strip casters. The effects of some factors, such as, the forming belt position, the forming belt contacting angle, the roll speed and the puddle form type on the continuity of the strip casting, the microstructure and surface quality were investigated. Al–12 mass%Si alloy was used as the experimental material. As the result, the secondary cooling effect by the equipment of the forming belt was proved. Producing rapidly solidified strips in high roll speed up to 200 m/min became possible. And it became clear that puddle form type affects the surface quality and microstructure type. Without puddle, the forming belt forms the free solidified surface in semi-solid state and free solidified surface was improved.

収録刊行物

  • 軽金属

    軽金属 47(11), 632-637, 1997-11-30

    The Japan Institute of Light Metals

参考文献:  4件中 1-4件 を表示

被引用文献:  3件中 1-3件 を表示

各種コード

  • NII論文ID(NAID)
    10003796260
  • NII書誌ID(NCID)
    AN00069773
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    04515994
  • NDL 記事登録ID
    4342480
  • NDL 雑誌分類
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL 請求記号
    Z17-284
  • データ提供元
    CJP書誌  CJP引用  NDL  J-STAGE 
ページトップへ