フェライトの溝研削におけるエッジ・チッピングの創成

• 蓮田 裕一

  正会員 栃木県立宇都宮工業高等学校

• 貴志 浩三

  正会員 宇都宮大学

書誌事項

タイトル別名

• Edge-chipping Generation of Ferrite in Slot Grinding.
• フェライト ノ ミゾケンサク ニ オケル エッジ チッピング ノ ソウセイ

抄録

The purpose of this investigation is to clarify the edge-chipping generation-mechanism of ferrite in slot grinding. By releasing the grinding wheel quickly from the contact zone during the grinding operation, changes of edge-chipping size and of kerf width are measured. Edge-chipping size tends to decrease greatly in the grinding zone, while kerf width tends to increase greatly in the same zone. The changes of edge-chipping size and of kerf width are opposite. The sum of edge-chipping size and kerf width in the grinding zone shows a nearly constant value. It is seemed that the initial chipping which occurred at the tip of ground groove is continuously ground with small depth of cut by the side of the grinding wheel and that the initial chipping tends to be decreased by an increase of kerf width. Especially, in down cut and low work speed the apparent function of increasing of kerf width is shown.

収録刊行物

• 精密工学会誌

  精密工学会誌 62 (4), 559-563, 1996

  公益社団法人 精密工学会

キーワード

• chipping generation mechanism
• slot grinding
• ferrite
• edge-chipping
• kerf width

詳細情報

• CRID: 1390282679742082304
• NII論文ID: 110001372046
• NII論文ID: 10004272217
• NII書誌ID: AN1003250X
• DOI: 10.2493/jjspe.62.559
• ISSN: 1882675X
• ISSN: 09120289
• NDL書誌ID: 3947029
• Web Site: https://ndlsearch.ndl.go.jp/books/R000000004-I3947029
• 本文言語コード: ja
• データソース種別:
  • JaLC
  • NDL
  • Crossref
  • CiNii Articles
• 抄録ライセンスフラグ: 使用不可