Development of the Barrel Type Bellows.
-
- MORITA Ayumu
- Power & Industrial Systems R & D Laboratory, Hitachi Ltd.
-
- KAJIWARA Satoru
- Kokubu Adiministrative Division, Hitachi Ltd.
-
- TANIMIZU Toru
- Kokubu Adiministrative Division, Hitachi Ltd.
-
- TAKAHASHI Masayuki
- Power Distribution Systems Center, Mitsubishi Electric Corporation
-
- HASHIMOTO Takanori
- Kuze Bellows
-
- YOTSUMOTO Yoshiharu
- Destribution Engineering Divisior, Tokyo Electric Power Company
Bibliographic Information
- Other Title
-
- たる形ベローズの開発
- タルガタ ベローズ ノ カイハツ
Search this article
Abstract
This paper presents the development of the bending bellows named “barrel type bellows” for the multi-functional vacuum tube. Conventional bellows with a bending axis outside of the bellows is imposed the complex motions of bending and sliding, and the stress concentrates on the pleat near the end portions. Based on the numerical analysis, it is found that the concentrated stress is reduced by making the outer diameter increase continuously from the both ends toward the center. As a result, the offset width of the bellows decreases and the vacuum tube becomes small. The endurance test shows that the operating cycles are over 30, 000, which roughly corresponds to that predicted from the calculated stress and the fatigue data of the thin stainless sheet in Refs. 2) and 4).
Journal
-
- Shinku
-
Shinku 43 (2), 140-145, 2000
The Vacuum Society of Japan
- Tweet
Keywords
Details 詳細情報について
-
- CRID
- 1390001204064748416
-
- NII Article ID
- 10004561449
-
- NII Book ID
- AN00119871
-
- ISSN
- 18809413
- 05598516
-
- NDL BIB ID
- 5298182
-
- Text Lang
- ja
-
- Data Source
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed