書誌事項
- タイトル別名
-
- Casting Au-Ag-Pd Alloy to the Embedded Keeper of Magnetic Attachment. Part 1. Influence of Mold Temperature.
- Part 1. Influence of Mold Temperature
- 第1報係留温度の影響
この論文をさがす
抄録
A cast-soldering method was used for the keepers of magnetic attachments. However, there have been few studies concerning the effects of the cast-soldering method on keepers. In this study, this cast-soldering method was investigated by changing the mold temperature.<BR>Two commercially available keepers and a 12% Au-Ag-Pd casting alloy were used. Cast-soldering was performed at mold temperatures of 600, 700 and 800°C for 30 minutes. After cast-soldering, the interface between the keeper and the casting alloy was observed by light microscopy and scanning electron microscopy and analyzed with an X-ray electron microprobe.<BR>Microscopic observation revealed a black layer between the keeper and the casting alloy in all specimens. Scanning electron microscopy and X-ray electron microprobe analysis indicated that the black layer was composed of an oxidation layer with Fe and a gap. The black layer was larger at lower mold temperatures.<BR>The findings suggested that it is important to keep the mold at a proper temperature.
収録刊行物
-
- 日本補綴歯科学会雑誌
-
日本補綴歯科学会雑誌 44 (1), 122-128, 2000
社団法人 日本補綴歯科学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282679386986880
-
- NII論文ID
- 10008154767
-
- NII書誌ID
- AN00197911
-
- ISSN
- 1883177X
- 03895386
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可