球面のボールエンドミル加工における加工両創成機構の理論解析　２　　逃げ面干渉を考慮したねじれ刃による加工面形状の推定

DOI Web Site 被引用文献8件 参考文献17件

書誌事項

タイトル別名
  • Theoretical Analysis on Generating Mechanism of Machined Surface in Ball-nosed End Milling for Spherical Surface. (2nd Report). The Estimation of Machined Surface based on Spiral Cutting Edge in Consideration of Frank Interference.
  • キュウメン ノ ボール エンド ミル カコウ ニ オケル カコウメン ソウセイ キコウ ノ リロン カイセキ ダイ2ホウ ニゲ メン カンショウ オ コウリョ シタ ネジレハ ニ ヨル カコウメン ケイジョウ ノ スイテイ
  • The Estimation of Machined Surface baesd on Spiral Cutting Edge in Consideration of Frank Interference
  • 逃げ面干渉を考慮したねじれ刃による加工面形状の推定

この論文をさがす

抄録

This paper presents an analytical simulation method to estimate a machine profile in spherical milling with a ball-nosed spiral cutting edge tool. The height of machined profile is regarded as the cross point of the moving cutting edge and a specified normal line. The geometric equations determining the rotating angle of the tool and the cross point were formulated and solved originally in numerical calculations of Newton-Raphson method. The phase difference angle of the spiral cutting edge was measured and embedded into the formula. By developing the faster method to get the initial solution of the numerical calculations, a graphic simulation of the machined surface can be displayed three times faster than that in a case of a flat cutting edge. Also the discriminant of the interference between the flank of the tool and the machined surface has been formulated and introduced into the simulation method. Then the exact profile of machined surface could be estimated by the presented method. Through the formula development and graphic simulation, the landscape features of machined surface have been well recognized and the cusp height could be exactly estimated. Experimental simulations have been illustrated and the conclusions are described briefly.

収録刊行物

  • 精密工学会誌

    精密工学会誌 66 (7), 1150-1154, 2000

    公益社団法人 精密工学会

被引用文献 (8)*注記

もっと見る

参考文献 (17)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ