Continuous Rheocasting for Aluminum-Copper Alloys

この論文にアクセスする

この論文をさがす

著者

    • Ichikawa Kiyoshi ICHIKAWA Kiyoshi
    • Ecology-Oriented Structural Materials Group, Institute of Mechanical Systems Engineering, National Institute of Advanced Industrial Science and Technology (AIST), Ministry of Economy, Trade and Industry
    • Katoh Masahito KATOH Masahito
    • Ecology-Oriented Structural Materials Group, Institute of Mechanical Systems Engineering, National Institute of Advanced Industrial Science and Technology (AIST), Ministry of Economy, Trade and Industry
    • Asuke Fumio ASUKE Fumio
    • Ecology-Oriented Structural Materials Group, Institute of Mechanical Systems Engineering, National Institute of Advanced Industrial Science and Technology (AIST), Ministry of Economy, Trade and Industry

抄録

An experimental study was performed on the homogeneous refinement of microstructures and the improvement of mechanical properties in Al–5 mass%Cu and Al–10 mass%Cu alloys using a novel continuous rheocasting process. The crystal grain size in an Al–10 mass%Cu alloy sheet was 6.9±1.8 \\micron in the continuous rheocasting process, which was much finer than the typical grain sizes on the order of 100 \\micron for the conventional rheocasting process and the grain size of 72±26 \\micron in Al–10 mass%Cu alloy for the batch-type rheocasting by Ichikawa <I>et al.</I> The ultimate tensile strength in the Al–10%Cu alloy sheet was 248 MPa at room temperature, which was higher as compared to the tensile strength of 192 MPa in a die-cast Al–10 mass%Cu alloy. The tensile elongation in the Al–10 mass%Cu alloy sheet was 297% at 773 K, which was resulted from superplasticity. It is considered that the crystal grain size in the Al–10%Cu alloy is determined by the “big-bang” nucleation and the multiplication of crystal grains in the numerous spattered droplets made by a rotating screw-shaped stirrer in the continuous rheocasting process.

収録刊行物

  • Materials transactions

    Materials transactions 43(9), 2285-2291, 2002-09-01

    公益社団法人 日本金属学会

参考文献:  18件中 1-18件 を表示

各種コード

  • NII論文ID(NAID)
    10012326302
  • NII書誌ID(NCID)
    AA1151294X
  • 本文言語コード
    ENG
  • 資料種別
    ART
  • ISSN
    13459678
  • NDL 記事登録ID
    6313285
  • NDL 雑誌分類
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL 請求記号
    Z53-J286
  • データ提供元
    CJP書誌  NDL  J-STAGE 
ページトップへ