Electron Beam Welding of Zr50Cu30Ni10Al10 Bulk Glassy Alloys

書誌事項

タイトル別名
  • Electron Beam Welding of Zr<SUB>50</SUB>Cu<SUB>30</SUB>Ni<SUB>10</SUB>Al<SUB>10</SUB> Bulk Glassy Alloys

この論文をさがす

抄録

By using a conventional electron beam welding machine, an electron beam welding of Zr50Cu30Ni10Al10 bulk glassy plates has been achieved in the welding condition leading to the suppression of heat affected zone (HAZ). In order to obtain the cooling rate, which is sufficient for glass formation, the welding speed was controlled to be higher than 100 mm/s and the beam-radiated area should be limited to be smaller than 0.8 mm in diameter. Joint strength of the welded bulk glassy plate is about 1400 MPa, which is lower by 15% than the tensile strength (1650 MPa) of the glassy alloy. The fracture of the welded alloy plate occurs along shear slip plane across the welded area, reflecting good ductility in the welded area of the Zr50Cu30Ni10Al10 bulk glassy alloy.

収録刊行物

  • MATERIALS TRANSACTIONS

    MATERIALS TRANSACTIONS 43 (10), 2509-2515, 2002

    公益社団法人 日本金属学会

被引用文献 (7)*注記

もっと見る

参考文献 (22)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ