書誌事項
- タイトル別名
-
- Development of a Light-polymerized Resin for the Record Base Part 1 Comparison with Autopolymerizing Resin
- Part 1 Comparison with Autopolymerizing Resin
- 第1報常温重合レジンとの比較
この論文をさがす
抄録
Purpose: The record block for maxillomandibular registration of the denture is absolutely necessary in order to decide the mandibular position. This record block must provide sufficient strength so as not to cause deformation in the oral cavity. It must also fit the alveolar ridge well in order to keep accurate registration. Since most of the conventional materials for this purpose are not sufficient, a new specific light-polymerized resin was experimentally developed for the record base.<BR>Methods: The mechanical strength and suitability of the new material were examined in comparison with a conventional autopolymerizing resin.<BR>Results: 1) The transverse strength was equivalent to that of the autopolymerizing resin. 2) Although the shear bond strength was equivalent to the autopolymerizing resin, the intensity was drastically improved by the application of composite primer. 3) The light-polymerized resin and the autopolymerizing resin did not show any difference in suitability, and it was a clinical value without problem.<BR>Conclusions: From these findings, it was confirmed that the new light-polymerized resin had the physical property for clinical application as a material for the record base.
収録刊行物
-
- 日本補綴歯科学会雑誌
-
日本補綴歯科学会雑誌 50 (2), 238-244, 2006
社団法人 日本補綴歯科学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282679388365952
-
- NII論文ID
- 10017492575
-
- NII書誌ID
- AN00197911
-
- ISSN
- 1883177X
- 03895386
-
- PubMed
- 16790963
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- PubMed
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可