Analysis and Design of a Parallel CUK Power Factor Correction Circuit Based on Power Balance Control Technique

この論文にアクセスする

この論文をさがす

著者

抄録

The analysis and design of a parallel AC to DC CUK converter circuit based on power balance control technique for DC Distributed Power System (DPS) applications are presented. The three parallel modules system with fast dynamic response using single voltage loop control and inductor current calculator for input current wave shaping, inductor current sharing and output voltage regulation, while keeping the power factor very close to unity have been shown. The experimental prototype have been built with a DC output voltage -48V and output power 750W. Each converter operates in Continuous Conducting Mode (CCM) together with hysteresis current control. The experimental results indicate that such scheme is effective and offers the fast transient response. The results obtained are: power factor greater than 0.99 and input current Total Harmonic Distortion (THD) less than 3%. The system offers 85% efficiency and provide good current sharing among the converter modules.

収録刊行物

  • 電気学会論文誌. D, 産業応用部門誌 = The transactions of the Institute of Electrical Engineers of Japan. D, A publication of Industry Applications Society  

    電気学会論文誌. D, 産業応用部門誌 = The transactions of the Institute of Electrical Engineers of Japan. D, A publication of Industry Applications Society 126(5), 533-540, 2006-05-01 

    The Institute of Electrical Engineers of Japan

参考文献:  12件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

被引用文献:  1件

被引用文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10018111531
  • NII書誌ID(NCID)
    AN10012320
  • 本文言語コード
    ENG
  • 資料種別
    ART
  • ISSN
    09136339
  • NDL 記事登録ID
    7946576
  • NDL 雑誌分類
    ZN31(科学技術--電気工学・電気機械工業)
  • NDL 請求記号
    Z16-1608
  • データ提供元
    CJP書誌  CJP引用  NDL  J-STAGE 
ページトップへ