Modeling and Control of VSC Based DC Connection for Active Stall Wind Farms to Grid
Access this Article
Search this Article
Currently, there is an increasing trend to connect large MW wind farms to the transmission system. Therefore the power system becomes more vulnerable and dependent on the wind energy production. At the same time requirements that focus on the influence of the farms on the grid stability and power quality, and on the control capabilities of wind farms have already been established. The main trends of modern wind turbines/farms are clearly the variable speed operation and a grid connection through a power electronic interface, especially using doubly-fed induction generators. Using power electronics the control capabilities of these wind turbines/farms are extended and thus the grid requirements are fulfilled. However, the traditional squirrel-cage generators based wind turbines/wind farms directly connected to the grid does not have such control capabilities. They produce maximum possible power in continuous operation and are becoming disconnected in the case of a grid fault. Moreover, these wind turbines/farms cannot regulate their production and contribute to power system stability. A DC transmission system for connection of the active stall wind farms to the grid can be a solution to these problems. Such a system has special regulating properties e.g. decoupled control of active and reactive power, continuous AC voltage regulation, variable frequency control, black-start capability, etc. This paper focuses on the modeling of such systems and proposes a control method of a voltage source converter based DC transmission system for connecting active stall wind farms to the grid.
- IEEJ Transactions on Sensors and Micromachines
IEEJ Transactions on Sensors and Micromachines 126(5), 622-629, 2006-05-01
The Institute of Electrical Engineers of Japan