Fabrication of Fe-Based Bulk Amorphous Alloys Using Hot Metal and Commercial Ferro-Alloys
-
- Yi Seonghoon
- Department of Materials Science and Metallurgy, Kyungpook National University
-
- Kim Ki Buem
- Technische Universität Darmstadt, FB 11 Material- und Geowissenschaften, FG Physikalische Metallkunde
-
- Sohn Ho Sang
- Department of Materials Science and Metallurgy, Kyungpook National University
この論文をさがす
抄録
For commercial applications of Fe-based bulk amorphous alloys as structural materials, Fe-based bulk amorphous alloys that can be cost-effectively and massively produced have been developed using hot metal and ferro-alloys from a steel plant. The alloy Fe68.0C10.5Si4.4B6.5P8.6Al2.0 can be cast into a fully amorphous rod of 3 mm in diameter through a suction casting method. Upon heating the amorphous rod, a sequential crystallization behavior starting with the precipitation of fcc-Fe phase were observed. Since the crystallization kinetics was sluggish, the Fe-based bulk amorphous alloy can be used as a precursor for the fabrication of bulk nanostructured Fe alloy.
収録刊行物
-
- MATERIALS TRANSACTIONS
-
MATERIALS TRANSACTIONS 46 (10), 2237-2240, 2005
公益社団法人 日本金属学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282679227554432
-
- NII論文ID
- 130004452617
- 10018277733
-
- NII書誌ID
- AA1151294X
-
- ISSN
- 13475320
- 13459678
-
- NDL書誌ID
- 7487917
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可