磁気異方性センサを用いた曲管の非破壊応力診断 : 面外曲げへの拡張 Nondestructive Evaluation of Stress in Bent Pipe by Magnetic Anisotropy Sensor : Out-of-Plane Bending
A method is developed to nondestructively estimate stresses in bent pipes using a magnetic anisotropy sensor. The values measured by the magnetic method contain both stresses generated during manufacture and by external loads.Out-of-plane bending test and in-plane bending test using a mandrel elbow were performed. The values obtained by the magnetic method were regressed to Rodabaugh & George's theoretical equation for a bent pipe. From the regression curve obtained, it was possible to obtain the external moment that was purely applied to the bent pipe. The stress range where measurement is possible is smaller than that in a straight pipe, because the residual stress is greater than that of a straight pipe. If the theoretical stress calculation equation by Rodabaugh & George was used, it was possible to separate the residual stress from the stress produced by the external load, based on the magnetic method due to inplane bending and out-of-plane bending.
- 非破壊検査 = JOURNAL OF THE JAPANESE SOCIETY FOR NON-DESTRUCTIVE INSPECTION
非破壊検査 = JOURNAL OF THE JAPANESE SOCIETY FOR NON-DESTRUCTIVE INSPECTION 55(11), 580-587, 2006-11-01
The Japanese Society for Non-Destructive Inspection