絶縁用封止材として使われるエポキシ樹脂硬化反応の解析: 昇温工程の反応挙動の解析

• 串崎, 義幸

• 山田, 敏郎

• 多田, 薫

• 五十嵐, 充

• 蒲生, 正浩

書誌事項

タイトル別名

• ゼツエンヨウ フウシザイ ト シテ ツカワレル エポキシ ジュシ コウカ ハンノウ ノ カイセキ ショウオン コウテイ ノ ハンノウ キョドウ ノ カイセキ
• Analysis of Curing Reaction for Epoxy Resin Used for Electrical Insulator: Two-stage Cure Reaction with a Finite Element Method

抄録

Epoxy has been used widely in electronic devices because of its excellent electrical properties for insulators. In epoxy resin curing reaction process, phenomena such as heat of reaction, reaction progress (degree of cure, physical properties, etc.), cure shrinkage and viscoelastic behavior, are related intricately. It is known that there are serious problems of delamination at the metal- epoxy resin interface and crack failure in epoxy resin due to cure shrinkage when epoxy resin is used as encapsulating medium of insulators in electrical and electronic equipments. It is very difficult to make experimentally clear the mechanism of the delamination and crack failure occurring in electrical and electronic equipments during curing reaction. Though several papers have been reported on the attempts to predict the stress-strain behavior during curing reaction, their simulation model is proposed under the conditions without cure shrinkage, heat of reaction, reaction progress, delamination or crack failure. Therefore, previous works cannot be always applied to the practical production process. In order to solve these problems, the authors have proposed a new simulation model, which can applies to the curing process from potting (liquid state) to gelling (solid state) under a constant curing temperature. In this work, the authors have attempted the simulation with a finite element method for two-stage cure reaction as follows: Epoxy resin was potted between the inner and outer iron cylinders. The potted epoxy resin was cured under a given temperature before gelling and under a higher temperature during gelling (two-stage cure reaction). In order to express the two-stage cure reaction, the equation of cure reaction was corrected. The circumferential strain curves on the surface of outer iron cylinder predicted by the simulation are in good agreement with the experimental results.

収録刊行物

• 成形加工 = Journal of the Japan Society of Polymer Processing

  成形加工 = Journal of the Japan Society of Polymer Processing 18 (10), 752-758, 2006-10-20

  The Japan Society of Polymer Processing = プラスチック成形加工学会

キーワード

• Two-stage Curing reaction
• Viscoelasticity
• Epoxy Resin
• FEM

詳細情報

• CRID: 1050282810919086464
• NII論文ID: 10018455222
• NII書誌ID: AN10278882
• ISSN: 09154027
• NDL書誌ID: 8557746
• Web Site: http://hdl.handle.net/2297/36569
• Web Site: https://ndlsearch.ndl.go.jp/books/R000000004-I8557746
• 本文言語コード: ja
• 資料種別: journal article
• データソース種別:
  • IRDB
  • NDL
  • CiNii Articles