Treeing Breakdown in Inorganic-filler/LDPE Nano-composite Material
-
- Kurnianto Rudi
- Department of Electronic and Information Eng., Toyohashi University of Technology
-
- Murakami Yoshinobu
- Department of Electronic and Information Eng., Toyohashi University of Technology
-
- Nagao Masayuki
- Department of Electronic and Information Eng., Toyohashi University of Technology
-
- Hozumi Naohiro
- Department of Electrical Engineering, Aichi Institute of Technology
-
- Murata Yoshinao
- J-Power Systems Corporation
この論文をさがす
抄録
A nano-composite material of magnesium oxide (MgO) added to a low-density polyethylene (LDPE) was subjected to electrical tree breakdown investigation. The LDPE without nano-fillers was lower in breakdown voltage than the LDPE added with nano-fillers. The breakdown voltage was increased by increase of nano-filler concentrations in LDPE. This result much coincided with the result on tree inception voltage which was increased when the concentration of filler in LDPE was increased. It is considered that fillers would create such an obstruction to the tree bridging the counter electrode. However, even the tree had bridged the plate electrode; the breakdown was not always immediately to occur. There would be so-called time-lag between “bridging” and “final breakdown”. The time-lag to breakdown was increased with the nano-filler concentrations in LDPE. It is considered that the polymer nano-composites are more resistive against partial discharges than their base material.
収録刊行物
-
- 電気学会論文誌. A
-
電気学会論文誌. A 127 (1), 29-34, 2007
一般社団法人 電気学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001204593694976
-
- NII論文ID
- 10018456875
-
- NII書誌ID
- AN10136312
-
- ISSN
- 13475533
- 03854205
-
- NDL書誌ID
- 8624013
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可