ハーフブリッジ形ソフトスイッチングPWM高周波インバータを用いたアーク溶接機用DC-DC変換器 DC-DC Converter using Half-Bridge Soft Switching PWM Inverter for Arc Welder

この論文にアクセスする

この論文をさがす

著者

抄録

This paper presents a new circuit topology of dc bus line side active resonant snubber assisted voltage source high frequency link soft switching PWM half-bridge inverter type dc-dc power converter for arc welder. The proposed power converter is composed of a typical voltage source-fed half-bridge high frequency PWM inverter with a high frequency transformer link in addition to two dc bus line side power semiconductor switching devices for PWM control scheme and two capacitive lossless snubbers. All the active power switches in the half-bridge arm and dc bus lines can achieve ZCS turn-on and ZVS turn-off transition commutation and consequently the total switching power losses can be effectively reduced. As a result, a high switching frequency of using IGBTs can be actually selected more than about 22 kHz. The effectiveness of this new dc-dc power converter topology is proved to be more suitable for low voltage and large current dc-dc power supplies such as arc welder fro皿apractical point of view.

収録刊行物

  • 電気設備学会誌  

    電気設備学会誌 27(8), 669-678, 2007-08-10 

    The Institute of Electrical Installation Engineers of Japan

参考文献:  13件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10021135837
  • NII書誌ID(NCID)
    AN10067173
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    09100350
  • NDL 記事登録ID
    8924742
  • NDL 雑誌分類
    ZN31(科学技術--電気工学・電気機械工業)
  • NDL 請求記号
    Z16-1149
  • データ提供元
    CJP書誌  NDL  J-STAGE 
ページトップへ