Disbonding in Joint of Carbon to Nickel

この論文にアクセスする

この論文をさがす

著者

抄録

Carbon samples heat-treated at different temperatures of 1273 to 3273 K were bonded to nickel in the solid state in a vacuum using an RF induction furnace. The bending and shearing strengths of the joints were investigated. The feasibility of disbonding of the joints was investigated by heating in a vacuum. The fracture surfaces for the joints were also observed using a scanning electron microscope. Based on the results, the effects of the heat treatment of carbon on the interface strength of a joint were examined. With increasing heat treatment temperature, the joint strength of carbon to nickel is improved. Utilizing this property, the heat treatment of carbon is performed to adjust the interface strength of a joint. Moreover, by the selection of carbon materials heat-treated at a specific temperature (2023 or 2123 K), the design of the joining system with both bonding and disbonding properties is feasible.

収録刊行物

  • Materials transactions  

    Materials transactions 49(4), 760-765, 2008-04-01 

    The Japan Institute of Metals and Materials

参考文献:  10件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10021145774
  • NII書誌ID(NCID)
    AA1151294X
  • 本文言語コード
    ENG
  • 資料種別
    ART
  • ISSN
    13459678
  • NDL 記事登録ID
    9447333
  • NDL 雑誌分類
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL 請求記号
    Z53-J286
  • データ提供元
    CJP書誌  NDL  J-STAGE 
ページトップへ