Machinability of Experimental Ti-Cu Alloys

この論文にアクセスする

この論文をさがす

著者

抄録

This study is an investigation of the machinability of experimental Ti-Cu alloys (2, 5, and 10 mass% Cu) as new dental titanium alloy candidates for CAD/CAM use. The alloys were slotted with a vertical milling machine and carbide square end mills under two cutting conditions. Their machinability was evaluated through cutting force using a three-component force transducer fixed on the table of the milling machine. The horizontal cutting forces of the Ti-Cu alloys tended to increase as the concentration of copper increased. The feed force for Ti-10%Cu was more than twice as large as that for titanium under both cutting conditions. Alloying with copper reduced the machinability of titanium under the present cutting conditions. The adverse effect on the cutting force was attributed to the higher degree of tensile strength and hardness of the Ti-Cu alloys than of titanium.

収録刊行物

  • Materials transactions  

    Materials transactions 49(4), 800-804, 2008-04-01 

    日本金属学会

参考文献:  14件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10021145876
  • NII書誌ID(NCID)
    AA1151294X
  • 本文言語コード
    ENG
  • 資料種別
    ART
  • ISSN
    13459678
  • NDL 記事登録ID
    9447474
  • NDL 雑誌分類
    ZP41(科学技術--金属工学・鉱山工学)
  • NDL 請求記号
    Z53-J286
  • データ提供元
    CJP書誌  NDL  IR  J-STAGE 
ページトップへ