Effect of Machining Parameters on BK7 Optical Glass Using Conventional and Rotary Ultrasonic Machines

この論文にアクセスする

この論文をさがす

著者

    • Hamzah Esah HAMZAH Esah
    • Department of Materials Engineering, Faculty of Mechanical Engineering, Universiti Teknologi Malaysia
    • Sudin Izman SUDIN Izman
    • Department of Manufacturing and Industrial Engineering, Faculty of Mechanical Engineering, Universiti Teknologi Malaysia
    • ZAINAL ABIDIN Nor Najwa
    • Department of Materials Engineering, Faculty of Mechanical Engineering, Universiti Teknologi Malaysia
    • TAN Ming-Jiun
    • Department of Manufacturing and Industrial Engineering, Faculty of Mechanical Engineering, Universiti Teknologi Malaysia

抄録

This paper studies the machinability of BK7 optical glass by using conventional ultrasonic machining (USM) and rotary ultrasonic machining (RUM). For USM, the finer grit size gives low MRR, good surface finish, small chipping size and low opaqueness. In RUM, higher spindle speed gives good MRR, excellent surface finish, high opaqueness and small chipping size. Whilst higher feedrate gives high MRR, low surface finish, low opaqueness and small chipping size. The edge chipping size could be decreased with backing material.

収録刊行物

  • 実験力学 : journal of JSEM  

    実験力学 : journal of JSEM 8, 127-132, 2008-06-25 

    The Japanese Society for Experimental Mechanics

参考文献:  35件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10021156186
  • NII書誌ID(NCID)
    AA11822914
  • 本文言語コード
    ENG
  • 資料種別
    ART
  • ISSN
    13464930
  • NDL 記事登録ID
    9568260
  • NDL 雑誌分類
    ZM17(科学技術--科学技術一般--力学・応用力学)
  • NDL 請求記号
    Z74-C355
  • データ提供元
    CJP書誌  NDL  J-STAGE 
ページトップへ