Cleanability of Titanium and Stainless Steel Particles in Relation to Surface Charge Aspects

この論文をさがす

抄録

The cleanability of titanium and 316L stainless steel particles was studied in terms of their apparent surface charge density ( σapp). Bovine serum albumin (BSA) was used as the model fouling agent. Curves for the σ aap of titanium and stainless steel particles showed the apparent points of zero charge (pzcapp) of 4.6 and 8.5, respectively. Compared withthe curve for the σapp of stainless steel, that of titanium was characterized by small positive and large negative σapp values.The isotherms for BSA adsorption and the saturation amount of BSA adsorbed on titanium and stainless steel depended largely on the intrinsic properties of BSA. In continuous cleaning in a plug-flow column fed by a 0.05M NaOH solution, BSA was found to be faster desorbed from titanium than from stainless steel, and smaller amounts of BSA remaining after 120-min cleaning were observed on titanium. Kinetic analysis showed that the two first-order desorption rate constants, reflecting the rate of BSA desorption in the initial and later stages of cleaning, for titanium were respectively 1.7-fold and 1.3-fold higher than those values for stainless steel. It could be suggested that the better cleanability of titanium was probably due to the small binding strength of BSA on slightly negatively-charged titanium surfaces and due to their large negative σapp values underalkalinecleaning conditions.

収録刊行物

被引用文献 (7)*注記

もっと見る

参考文献 (36)*注記

もっと見る

詳細情報 詳細情報について

  • CRID
    1390001204465116288
  • NII論文ID
    10021184130
  • NII書誌ID
    AA11169621
  • DOI
    10.4265/bio.13.9
  • COI
    1:CAS:528:DC%2BD1cXksFKhurg%3D
  • ISSN
    18840205
    13424815
    http://id.crossref.org/issn/13424815
  • PubMed
    18432111
  • 本文言語コード
    en
  • データソース種別
    • JaLC
    • Crossref
    • PubMed
    • CiNii Articles
  • 抄録ライセンスフラグ
    使用不可

問題の指摘

ページトップへ