Introduction of Parallel Measurement and Supplementary Apparatus Newly Developed

この論文にアクセスする

この論文をさがす

著者

    • OKADA Masatsugu
    • Department of Removable Prosthodontics and Occlusion, Osaka Dental University
    • INOUE Hiroshi
    • Department of Removable Prosthodontics and Occlusion, Osaka Dental University

抄録

Prosthesis has a close relation with parallel. When installing prostheses, sometimes dentists need to reform abutment teeth or remaining teeth. In the case of partial denture, remaining teeth and its contours should be parallel. In the case of crown & bridge, abutment teeth and pins should be parallel. In the case of implant, success of the following prostheses depends on implant's direction. The ideal preparation is not easy even for skilled dentists, much less for students and beginners. If they use parallel measurements, they would save time and its accuracy gets higher. Therefore, we invented the parallel measurement apparatus which is convenient for clinical use.

収録刊行物

  • Prosthodontic research & practice  

    Prosthodontic research & practice 7(2), 243-245, 2008-07-01 

    Japan Prosthodontic Society

参考文献:  3件

参考文献を見るにはログインが必要です。ユーザIDをお持ちでない方は新規登録してください。

各種コード

  • NII論文ID(NAID)
    10021955336
  • NII書誌ID(NCID)
    AA11728086
  • 本文言語コード
    ENG
  • 資料種別
    NOT
  • ISSN
    13477021
  • データ提供元
    CJP書誌  J-STAGE 
ページトップへ