Transient Behavior of Burden Descending and Influence of Cohesive Zone Shape on Solid Flow and Stress Distribution in Blast Furnace by Discrete Element Method

DOI Web Site 被引用文献8件 参考文献21件
  • Fan Zhengyun
    Institute of Multidisciplinary Research for Advanced Materials (IMRAM), Tohoku University School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing
  • Natsui Shungo
    Institute of Multidisciplinary Research for Advanced Materials (IMRAM), Tohoku University
  • Ueda Shigeru
    Institute of Multidisciplinary Research for Advanced Materials (IMRAM), Tohoku University
  • Yang Tianjun
    School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing
  • Kano Junya
    Institute of Multidisciplinary Research for Advanced Materials (IMRAM), Tohoku University
  • Inoue Ryo
    Institute of Multidisciplinary Research for Advanced Materials (IMRAM), Tohoku University
  • Ariyama Tatsuro
    Institute of Multidisciplinary Research for Advanced Materials (IMRAM), Tohoku University

この論文をさがす

抄録

The present investigation intends to elucidate the transient behavior of burden descending, the influence of cohesive zone shape on the solid flow and the stress field through three-dimensional analysis by discrete element method (DEM) in blast furnace. Although many continuum models were developed to analyze the in-furnace phenomena such as solid flow, DEM enables to analyze the unsteady state solid flow, the stress distribution and slip of burden in the three dimensional state. In this study, it was clarified that the solid flow in blast furnace was composed of steady flow and transient flow which caused by burden charge and slip around raceway. Burden charge instantaneously causes high stress region and high velocity region to spread from upper part to lower part. High velocity region caused by slip around raceway spreads upwards and mitigates the stress field in the vicinity of raceway. The cohesive zone shape almost does not affect on the particle movement in the upper part of shaft and deadman shape. However, the distribution of high stress region and high slipping region is affected by the cohesive zone shape. Asymmetric high stress and slipping distribution are formed in the case of biased cohesive zone, and high cohesive zone enlarges the region of high stress. Weak slipping region in the upper part of shaft tends to be mitigated by the stress field in upper part. Belly receives the maximum stress from burden. The normal stress acting on the bottom is concentrated on the center of bottom by the buoyancy effect of pig iron in the hearth.

収録刊行物

被引用文献 (8)*注記

もっと見る

参考文献 (21)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ