書誌事項
- タイトル別名
-
- Thermal deformation rate of grinding wheel in plunge grinding process.
- ケンサク カコウ ニ オケル トイシ ノ ネツ ヘンケイ ソクド ノ ケンキュ
この論文をさがす
抄録
The thermal deformation rate of wheel has been measured by using air-micrometer in process of cylindrical wet plunge grinding. By taking the thermal deformations rate of wheel and workpiece into account, the size generation process is experimentally analyzed. Main conclusions are as follows : (1) When using resinoid wheel which contains aluminium powder in bond materials, the thermal deformation rate of wheel rapidly increases and shows sharp peak in spark-in state, becomes zero in steady state and then rapidly decreases in spark-out state. (2) In spark-in state the actual size generation rate increases abruptly and exceeds the effective plunge speed because the thermal deformations rate of wheel and workpiece increase rapidly, and in spark-out state the actual size generation decreases more rapidly than the observed size generation rate. (3) In the case of the grinding heat strikingly generates, the processes of size generation, grinding forces, grinding temperature of wheel and workpiece and residual stock depend on the relative infeed rate, which is regarded with the thermal deformations rate of wheel and workpiece.
収録刊行物
-
- 精密工学会誌
-
精密工学会誌 55 (2), 354-359, 1989
公益社団法人 精密工学会
- Tweet
キーワード
詳細情報
-
- CRID
- 1390001204796763520
-
- NII論文ID
- 110001369858
- 10002972319
-
- NII書誌ID
- AN1003250X
-
- ISSN
- 1882675X
- 09120289
-
- NDL書誌ID
- 3218359
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可