書誌事項
- タイトル別名
-
- Combinatorial Optimization Method for Parts Matching in a Precision Assembly System Using Selective Assembly and Micro-Machining.
- センタク クミタテ ト ビサイ カコウ オ ヘイヨウ シタ コウセイド クミタテ システム ニ オケル ブヒン ノ クミアワセ サイテキカ シュホウ
この論文をさがす
抄録
With selective assembly based on the combinatorial optimization method, a combination of parts is optimized so that high quality assembled units are obtained in a lot unit at the maximum assembly rate while dimensions of each part are referred to appropriately. The assembly method proposed in this study combines selective assembly based on a combinatorial optimization method with micro-machining so as to produce high precision assembled units. This method is applied to the high precision assembly system where hole parts are combined with shaft parts. Further, micro-machining used for the correction of the dimensions of the shaft parts is taken into consideration during the optimization of the parts combination, and it is attempted to verify the performance by simulation. This system is effective in a small lot production, where higher assembly rates can not be attained with conventional methods, in such that a higher rate is obtained if micro-machining is used alongside. With the combinatorial optimization method for parts where micro-machining is taken into consideration in advance, maximum micro-machining dimension and maximum machining time of the shaft parts can be greatly reduced and the number of assembled units close to the ideal state is increased.
収録刊行物
-
- 精密工学会誌
-
精密工学会誌 65 (11), 1579-1583, 1999
公益社団法人 精密工学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282679742623104
-
- NII論文ID
- 110001372558
- 20000319597
-
- NII書誌ID
- AN1003250X
-
- ISSN
- 1882675X
- 09120289
-
- NDL書誌ID
- 4988777
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可