Machining Accuracy in End-milling with Oil Film on Water Fog Metal Working Fluid
-
- KAWATA Keiichi
- 愛知県産業技術研究所
-
- NAKAMURA Takashi
- 名古屋工業大学
-
- MATSUBARA Tomio
- 名古屋工業大学
-
- SATO Yutaka
- 愛知県産業技術研究所
Bibliographic Information
- Other Title
-
- 油膜付水滴加工液を用いたエンドミル加工の加工精度
- ユマク ツキ スイテキ カコウエキ オ モチイタ エンドミル カコウ ノ カコウ セイド
Search this article
Abstract
Recently, waste treatments in the traditional coolant system have been causing increase in manufacturing costs because of environmental concern. A new cutting fluid supply system (Oil film on Water fog: OoW) has been proposed for an environmental measure. The new system supplies the comparatively large water particles covered with very thin vegetable oil to a machining point with air jet. In this paper, milling tests, shaping two cylindrical bosses from an aluminum alloy block, are carried out, and the machining accuracy is examined for the practical use of this system. The experimental results are compared with the results used conventional coolant and minimal quantity of lubricant (MQL). As OoW has an enough cooling ability, the accuracy of products with OoW is finer than that with MQL, and is as same as that with conventional coolant. Consequently, it is concluded that the new system is expectable as one of the ecological-friendly machining methods.
Journal
-
- Journal of the Japan Society for Precision Engineering
-
Journal of the Japan Society for Precision Engineering 69 (9), 1342-1347, 2003
The Japan Society for Precision Engineering
- Tweet
Keywords
Details 詳細情報について
-
- CRID
- 1390001204797015680
-
- NII Article ID
- 110001373618
- 10012853974
-
- NII Book ID
- AN1003250X
-
- ISSN
- 1882675X
- 09120289
- http://id.crossref.org/issn/09120289
-
- NDL BIB ID
- 6672842
-
- Text Lang
- ja
-
- Data Source
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed