Moを含む準安定オーステナイト系ステンレス鋼の逆変態機構と機械的性質

DOI Web Site Web Site 被引用文献3件 参考文献3件

書誌事項

タイトル別名
  • Process of Reversion and Mechanical Properties in Metastable Austenitic Stainless Steels Containing Molybdenum
  • Mo オ フクム ジュン アンテイ オーステナイトケイ ステンレス コウ ノ

この論文をさがす

抄録

Effect of molybdenum on the behavior of reversion of deformation induced martensite to austenite and the mechanical properties of specimens containing reversed austenite were investigated within (15.5 13)% Cr-11%Ni-(02.5)%Mo steels by means of transmission electron microscopy, magnetic analysis and tensile testing. Reversion treatment of martensite to austenite was performed at a higher heating rate using a salt bath and at lower heating rate using an electric furnace. The results obtained are as follows.<BR>(1) The steels used almost transform to lath martensite ( a') from austenite (γ) by 90% cold rolling at 290 K. Effect of molybdenum on y stability against deformation is almost same as that of chromium.<BR>(2) The temperature range for reversion rises with increasing molybdenum content.<BR>(3) In case of 923 K annealing at a higher heating rate, a process of reversion is changed from a martensitic type to a diffusional one with increasing molybdenum content. A 13%Cr-11%Ni-2.5%Mo steel which reverts to γ by a diffusional process has an ultra fine austenitic structure with a mean grain size of 0.2 μm giving a high 0.2% proof stress of 0.8 GPa, tensile strength of 1.0 GPa, and elongation of 30%.<BR>(4) In case of 923 K annealing at a lower heating rate, a' reverts to γ by a diffusional process at lower heating temperatures. Therefore, molybdnum content of 0.5% is enough to obtain a high strergth steel.

収録刊行物

  • 鉄と鋼

    鉄と鋼 76 (10), 1728-1735, 1990

    一般社団法人 日本鉄鋼協会

被引用文献 (3)*注記

もっと見る

参考文献 (3)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ