ペダリング運動時の下肢関節トルクにおけるサイクリストと非サイクリストの比較

DOI Web Site Web Site 被引用文献7件 参考文献28件

書誌事項

タイトル別名
  • A COMPARISON BETWEEN CYCLISTS AND NONCYCLISTS OF JOINT TORQUE OF THE LOWER EXTREMITIES DURING PEDALING
  • ペダリング ウンドウジ ノ カシ カンセツ トルク ニ オケル サイクリスト ト ヒサイクリスト ノ ヒカク

この論文をさがす

抄録

The purpose of this study was to compare the effect between cyclists and noncyclists of pedal rates on ankle, knee, and hip joint torque during pedaling exercises. Six male cyclists (CY) and seven male noncyclists (NC) pedaled at 40, 60, 90 and 120 rpm with a power output of 200 W. The lower limb was modeled as three rigid segment links constrained to plane motion. Based on the Newton-Euler method, the equation for each segment was constructed and solved on a computer using pedal force, pedal, crank, and lower limb position data to calculate torque at the ankle, knee, and hip joints. The average planter flexor torque decreased with increasing pedal rates in both groups. The average knee extensor torque for CY decreased up to 90 rpm, and then leveled off at 120 rpm. These results were similar to NC. The average knee flexor torque in both groups remained steady over all pedal rates. The average hip extensor torque for CY decreased significantly up to 90 rpm where it showed the lowest value, but increased at 120 rpm. For NC, the average hip extensor torque did not decrease at 90 rpm compared with 60 rpm, and was significantly higher than CY at 120 rpm (CY : 28.1 ± 9.0 Nm, NC : 38.6 ± 6.7 Nm, p<0.05) . The average hip flexsor torque for NC at 120 rpm increased significanly from 90 rpm, and was significantly higher than CY (CY : 11.6±2.9 Nm, NC : 22.6±11.8 Nm, p<0.05) . These results suggest that it would be better for cyclists to select a pedal rate of between 90 to 110 rpm to minimize joint torque, and, as a result, reduce peripheral muscle fatigue.

収録刊行物

  • 体力科学

    体力科学 48 (5), 547-558, 1999

    一般社団法人日本体力医学会

被引用文献 (7)*注記

もっと見る

参考文献 (28)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ