1600°CにおけるSiO2‐TiO2‐Al2O3系融液の密度,粘度及び表面張力の測定

書誌事項

タイトル別名
  • Measurement of Density, Viscosity and Surface Tension of the Melt of the System SiO<sub>2</sub>-TiO<sub>2</sub>-Al<sub>2</sub>O<sub>3</sub> at 1600°C
  • 1600ドC ニ オケル SiO2 TiO2 Al2O3ケイ ユウエキ ノ ミ

この論文をさがす

抄録

Density, viscosity and surface tension of melts in the system SiO2-TiO2-Al2O3 at 1600°C have been measured by means of the Archimedes' method with two spheres, the drawing sphere method and the Wilhelmy's method, respectively. The accuracies of these measurements were confirmed with the molten B2O3 in the temperature range from 400° to 1400°C. As the result, density and viscosity of the molten B2O3 approximately agreed with values of literatures, but surface tension was affected by viscosity of the melt. However, influence of viscosity of the melt on surface tension could be taken off by a modification of “intermittent lowering”. When the contents of Al2O3 in the system SiO2-TiO2-Al2O3 were in the range from the eutectic composition of the system SiO2-TiO2 (89.5wt% SiO2, 10.5wt% TiO2) up to about 12.5wt% Al2O3, all the values of density, viscosity and surface tension of the melts decreased with increase of Al2O3 content. Above 12.5wt% Al2O3, these values increased with increase of Al2O3 content because of the formation of mullite in the melt.

収録刊行物

  • 窯業協會誌

    窯業協會誌 90 (1041), 262-269, 1982

    公益社団法人 日本セラミックス協会

被引用文献 (1)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ