書誌事項
- タイトル別名
-
- Machinability of TiAl Intermetallic Compounds Evaluated by Mechanical Strength
抄録
This paper describes the machinability evaluated by mechanical strength of workpiece when wire electrical discharge machining, cutting, grinding and polishing of titanium aluminide intermetallic compounds. The results obtained from this study are as follows : Surface defects and edge breakouts are formed along the layer direction of lamellar structure. Bending tests whose specimen are machined by the four methods are conducted. Grinding and polishing specimens have superior strength to cutting and wire electrical discharge machining specimens. In the case of lower strength specimens, the breakouts or crackes are observed at edge. It is proved that the strengths are related to formation mechanisms of surface and edge defects correlated with machining method.
収録刊行物
-
- 生産加工・工作機械部門講演会 : 生産と加工に関する学術講演会
-
生産加工・工作機械部門講演会 : 生産と加工に関する学術講演会 2000.2 (0), 211-212, 2000
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282680876375168
-
- NII論文ID
- 110002485300
-
- ISSN
- 24243094
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可